| Radiation leakage | No leakage, international standard:≤1μSv/h |
| Lead glass observation window | Transparent lead glass window shields radiation to observe the
inner status. |
| Window and back door safety interlock | Once users open the window or back door, X-ray tube will power off
immediately. When the window or back door is open, users can't turn
on the X-ray. |
| Electromagnetic safety switch | Lock once the X-ray is on, users can't open the observation window. |
| Emergency stop | Next to the operation position, press to power off |
| Tube protection | User can't leave the software to if you don't close the X-ray tube. |
| Function module | Operation |
|---|
| Keyboard and mouse can finish all operations | |
| X-ray tube control | Using mouse to click the X button can turn on or off the X-ray. The
real-time tube voltage and current value will display beside, users
can click up and down button, or drag the slider, or type to
adjust. |
| Status bar | Indicates the interlock status, pre-heat status, and X-ray status
by flashing alternately red and green. |
| Image effect adjustment | The brightness, contrast and gain of the image can be adjusted
freely to achieve a satisfactory result. |
| Product list | Users can save the inspection parameters such as Z-axis position,
brightness, contrast and gain, and can directly call the parameters
when inspecting the same product, to improve the inspection
efficiency. |
| Navigation window | After the camera takes a photo of the table, click anywhere in the
photo, the table will move to the place you click and display on
the screen. |
| Motion axis status | Display real-time coordinates. |
| Inspection result | The measurement results (voids rate, distance, area, etc., set by
users) display in order. |
| Speed control | The movement speed of each axis can be adjusted to slow, normal and
fast. |
| Voids rate measurement | Automatic calculation Click on two points to determine a rectangle.
The software automatically finds and measures the edge of the
solder ball in the rectangle, the pad and the internal voids, and
can get the data of the voids rate, the area of the solder ball,
the circumference, the biggest voids rate, the length and the
width, and indicates NG or OK by red and green. Parameters
adjustment Users can adjust the grayscale threshold, pixel,
contrast, size filtering and other parameters to get accurate
results of automatic calculation. Add voids manually Users can draw
a polygon or a free figure and calculate it as a void into the void
rate. Save parameters Users can save parameters such as grayscale
threshold, pixel, contrast, size filtering and other parameters,
and can directly call the parameters when detecting the same
product, to improve the detection efficiency. |
| Other measurement function | Distance Click the A and B points to set as the baseline, then
click the C point to measure the vertical distance from the C point
to the baseline. Distance rate It is mostly used to measure the
soldering rate of the through-hole. Set one more point "D" than the
distance. Divide the vertical distance from the D point to baseline
by the vertical distance of the C point, to obtain the percentage
ratio of the vertical distance of D to C. Angle Click the A and B
points to set as the baseline, then click the C point to measure
the angle between the BA and BC rays. Radius It is mostly used to
measure round components such as solder balls. Click three points
to determine a circle and measure the circumference, area and
radius. Perimeter It is mostly used to measure square components,
click two points to determine a square, measure the length, width
and area. |
