Product Overview
This dustproof glue dispensing machine combines a long 1450 mm
travel range, a sealed work area, and a vision‑guided dispensing
head to place adhesives accurately on large or multiple parts. It
is built for electronics modules, large assemblies and lines where
cleanliness and repeatable glue placement matter. The system
reduces rework by combining precise dosing, repeatable motion and
on‑board visual verification.
Problem
Large or multiple‑part boards and housings are hard to dose
accurately with hand or small desktop dispensers. Dust,
inconsistent motion and lack of inspection lead to misplaced
deposits, bridging, and higher scrap.
Cause
Manual dosing and open machines allow contaminants, and short
travel machines require repositioning or part fixtures that slow
throughput. Without visual confirmation, missed or off‑center
deposits are not caught until later, increasing rework.
Solution
This machine offers a dustproof enclosure, a long 1450 mm X stroke
to cover bigger assemblies, precise motion control, and an
integrated camera to check glue placement immediately. The combined
features let operators run longer batches with fewer stops, verify
each deposit in real time, and keep the line cleaner and more
reliable.
Application
- Large PCB or module dispensing where single pass coverage is
needed.
- Optical or camera module assembly requiring clean environment and
verified glue dots.
- Connector and housing sealing on long panels or rails.
- Production lines that combine dispensing and immediate visual check
to reduce rework.
How It Works
The system moves the dispensing head over the part using servo
drives across a 1450 mm X stroke. A vision camera locates fiducials
or pads, the controller executes the stored recipe, and the chosen
dispense head deposits glue. The camera then inspects the dot or
bead; if placement or volume is outside tolerance the system flags
the part or triggers an automatic correction routine. The enclosure
reduces dust entry and supports controlled cleaning intervals.
How To Choose
- Part size: confirm dimensions so the 1450mm stroke covers the part
or array without re‑positioning.
- Fluid type: select dispense head (syringe, auger, jet) based on
viscosity and particle content.
- Throughput: provide cycle time and batch size to size motion
profiles and feeder options.
- Inspection need: decide whether one camera is enough or if full
coverage inspection is required.
- Integration: state robot interface or conveyor details for inline
installation and electrical/air supply.
- Service plan: consider a maintenance kit and spare dispense nozzles
for high duty cycles.
FAQ
Q1: Does the machine support my glue type?
A1: It supports syringe, auger and valve heads. Provide glue
viscosity and solids data and we will recommend the head and
parameters.
Q2: Is the enclosure fully sealed against dust?
A2: The unit is dustproof with filtered access panels; for stricter
needs we offer filtered air and positive pressure options.
Q3: Can I add more cameras or a barcode reader?
A3: Yes. The system is modular and can include additional cameras,
barcode readers and external sensors.
Q4: How precise is the placement?
A4: Typical positioning accuracy is ±0.05 mm with repeatability
±0.02~0.05 mm after tuning; final numbers depend on chosen dispense
head and part fixturing.
Q5: Do you provide integration and on‑site commissioning?
A5: Yes. Mingseal offers on‑site commissioning, robot integration
support and training packages.
