| Production line | 2000T offshore XL monopile |
| Composed | 1drive unit + 3idler unit (hydraulic lift) |
| Max. Loading capacity | 2000Ton (1power & 3idler) |
| Workpiece dia. range | ø3,000~ø10,000mm. |
| Wheel material | Forged steel |
| Roller center distance | 2100~4500mm |
| The distance between ground and rotator center | 1,850mm ( Return to zero point.) |
| Roller center moving distance and adjustment method | 1.The idler roller seat is fixed by bolts. 2.Adjust the center distance of the roller with bolt holes. 3.Roller seat moving distance is 150mm. |
| Rotator walking method | 1. One unit of rotator is electric walking and the other one is
unpowered walking. 2. When the roller bed is walking, the maximum load is 1000 tons. 3. A group of rotator can move on the track at full load. 4. Electric walking speed is 230mm ~2300 mm/min |
| Group pair lifting drive | Hydraulic. |
| Hydraulic station | 1.Independent hydraulic station for each rotator. 2.Each hydraulic cylinder is equipped with an independent oil
pressure gauge, and there is a comparison table of
pressure-convertible load, which is recorded in the manual. |
| Rotator control function | 1.Low voltage (24V) wired (30M)/wireless remote control (100M). 2.Control cable length 30m, and must be provided a set control
cable for spare parts. 3.The grounding of the electrical components of the control box
must meet the electrical code requirements. 4.Cylinder lifting stroke and walking control. 5.Stop & E-stop button and synchronized function. 6.The remote control must have the above functions. 7.If the wireless remote control is damaged, it can use the wired
control to operate. 8.Each hydraulic cylinder can operate independently and with
linkage capability |
| Electronic control part | 1.Hydraulic station and power control box need to be protected. (windproof, dustproof, waterproof) 2.Electronic control box and elements can be fast disassembled. 3.The electronic control box and components need to adapt to the subtropical & island-type climate. 4.Perfect protection circuit (windproof, dustproof, waterproof). |
| Transmission & gap protection | Windproof, dustproof, waterproof. |
| Rotator weight and lifting method | 1.The weight of the rotator must be clearly marked on the drawing
and sprayed on the rotator. 2.The rotator needs to provide and set the ideal lifting position
and method and mark it on the drawing |
| Rotator stabilization and anti-roll device | 1.Set holding track device, the design drawings must be provided
and recorded in the manual. 2.A stable device in contact with the ground is required at the
periphery of the rotator. 3.When the rotator is fully loaded and not moving, the rotator can
be stabilized. |
| Protective | Need to set up a variety of protection devices, such as ELCB,
Electrical fuse, and so on. |
| Maintenance spares | 1.Must be used international label. |
