High Temperature Materials Cooling Long Lifetime Industrial
Centrifugal Fan
Introduction
The 5-06 series industrial centrifugal fan can be used in the
feeding system of 2-670t/h steam boiler in thermal power plants, it
can also meet the requirements of the high-pressure head
performance parameters of the fluidized bed furnace.
High Temperature Materials Cooling Long Lifetime Industrial
Centrifugal Fan can be used for more than four years when the concentration of
impurities is less than 200 mg/m3.
If it contains a lot of impurities, it also can be used, but it
will shorten the service life.
The maximum operating temperature of the induced draft fan must not
exceed 250°C.
The performance of the fan is expressed by parameters such as fan
flow, full pressure, spindle speed, shaft power and efficiency.
Technical data
industrial fan series | industrial fan model | Rotation Speed
(r/min) | Total Pressure
(Pa) | Air Capacity
(m³/h) | Power
(kW) |
| 5-06 | 8D | 1450 | 2592～1989 | 12028～20607 | 15 |
| 10D | 1450 | 4051～3108 | 23493～40249 | 55 |
| 11D | 1450 | 3036～2329 | 31269～53571 | 55 |
| 12.4D | 1450 | 3858～2960 | 44792～76740 | 90 |
Advantages and Features
1. Impeller:
12 pieces of backward aerofoil blades are welded between the Arc
cone front plate and the flat shaped rear plate. Because of the use
of airfoil blades, the fan is guaranteed to have high efficiency,
low noise and high strength. The impeller is corrected by static
and dynamic balance, so the operation is stable. Forced draught fan
and induced draught fan of the same machine number have same
impeller structure.
2. Casing:
The industrial centrifugal fan casing is a volute welded by ordinary steel plates.
The casing of a single suction fan is made in three different
forms: The No. 8 to 12 casing is made into an integral structure
and cannot be disassembled; The No. 14 to 16 casing is made into a
two open structure; The No. 18~29.5 casing is made into a three
open structure.
The induced draft fan and the volute plate are appropriately
thickened to prevent wear.
3. Inlet:
The converging and streamlined air inlet is made into a unitary
structure and bolted to the inlet side of the fan.
