CAB Electric Aluminium Radiator Brazing Furnace 1000 - 250 -
10000MM
Application
This aluminium radiator brazing furnace can be used to braze auto
aluminum radiators.
RRODUCTIVITY &CAPACITY (Typical Size)
Production line can be available to continuous brazing the
following parts.
| Product Type | Width(mm) | Length(mm) | Depth(mm) | Required Piece/Hour |
| Aluminum Radiator | 600 | 600 | 48 | 60 |
SCOPE OF SUPPLY
Degreasing Furnace
Fluxing System
Drying Furnace
Front Curtain Chamber system
Brazing Furnace
Air Cooling System
Rear Curtain Chamber
Air Blast System
Control System
Technical Parameters
| Reference Product | Radiator |
| Heating Method | Electricity |
| Maximum Usable Height About Mesh-belt | 250mm |
| Mesh-belt Speed Range | 200-1000mm/min |
| Mesh-belt Width | 1000mm |
| Loading Surface Height | 850mm |
| Power | Rated Power: 700KW |
| Total Length | About 47meters |
Equipment Advantages
1) The aluminum radiator brazing furnace adopts high performance
porcelain fiber cotton material for heat preservation purpose.
The furnace is able to rise to 630℃ from the ambient temperature in
around 2 hours.
2) The muffle of the brazing oven is once-formed by the large size
bending machine, and is made from Sweden 316L steel plate
and 304 steel plate. 8M muffle is formed by one-time bending, and
only there is one v-slot at the bottom of the muffle. The complete
muffle is only with 2 side welding lines. The one-time forming
muffle could reduce the misshapening effect at welding and also
deformation at the heating process.
3) The zones of the brazing furnace are divided based on upper,
lower, rear and back area. The heating power is adjusted through
power and voltage regulator so that the furnace could achieve an
ideal temperature uniformity of ±1℃. The brazing area could
achieve a temperature uniformity of ±2℃ so that it could meet the
brazing requirements.
4) The temperature controller has the PID regulation function to
achieve a smooth temperature rise. Also the temperature controller
has the over-temperature alarm. The mesh belt is steplessly
regulated through the inverter. The driving mechanism is started up
in the acceleration manner, and stopped in the deceleration manner
to reduce the tension of the mesh belt.
5) the CAB aluminium radiator brazing furnace has a complete
control system integrating intelligent control, alarm and
protection system.
The real-time temperature recording function provide the process
data of different products.
6) The area of the fluxing chamber which contacts the flux is made
of stainless steel material. The two side walls of the fluxing
chamber
are both set with an observation window to observe the fluxing
performance. The fluxing nozzles have a 90º fan-shape spraying to
prevent
nozzle blockage. There is a filtering net for recycling the flux to
prevent damage to the fluxing pump.
7) The dry air cooling room is set with a slag cleaning chamber.
There is a side door of the slag cleaning chamber for allowing the
worker
to clean the flux slags. In comparison to the traditional water
cooling chamber, the dry cooling room don’t have the risk of
corrosion because
of water and deformation of the chamber because of cold and heat.
There is no need for cooling water.
8) power at temperature rising stage: 100%; power at the brazing
stage: ≤60%
Company Introduction
Our company mainly supplies the aluminum radiator making machines
such as aluminum fin machine, aluminum radiator core builder,
aluminum radiator plastic tank crimping machine, aluminium radiator
brazing furnace (or called as CAB brazing furnace) air leak tester,
header mold, plastic tank mold, etc.
