Good price rubber cable PP water level switch cable float switch
made in china
MC water pump float switch is widely used to control the liquid
level.
Our float switch quality is stable, safe, and pass CE
approval.Flaot Switch's operation voltage is 220vac, and current
can be up to 10A. Applies to branch water,sewage,aid-base solution
and oil.float switch make use of mercury switch as contact
component. When liquid lift up to contact float, the float will
have variable angles. The switch will have ON or OFF contact signal
output when the angle is larger than 10 Degree.
1.Simple construction,reliable performance of cable float
switch/water pump, tank float switch
The product can output stable and reliable switch control signal of
"of making", breaking "without any fault action,so its eliability
is very high and antiinter-ference is strong .
2. Sturdy and durable,need not maintain of cable float switch/water
pump, tank float switch
The product can be used for a long time after it being
installed.Almostno maintence and repairing problem would occur
during its operation period.
product details
1. Good material
The use of high purity copper wire, thick wire core, enough to
achieve small resistance, less heat.
2. heat conduction
Environmental protection PP shell, non-toxic, tasteless, with good
electrical conductivity and insu.
3. Heavy hammer principle
Hammer with working principle diagram for easy debugging and
installation.
Installation
Use the black and blue wire.
when the float is on the level surface,the contact is under the
obstructed status,when the float is under the water,the contact is
turn-on status;
Use the black and yellow wire
When the float is on the level surface,the contact si turn-on
status,when is under the water,the contact is the obstructure
status;
Installation of fixed hammer
The level control height is decided by the cable length of magnetic
float type level switch and the position of the hammer;
The ways of install the hammer
Displace snap ring of the plastic non-cone terminal,and to the
appropriate place on the cable.
Then let the cable penetrate the terminal of the plastic cone,the
snap ring of set on the cable limit the position of the hammer;
Finally,fixed the cable outside of the container,let the cable
connect to control box and avoid using middle joint.if it need
joint forbid to put the joint in he water.
Specification
| Brand Name | MC |
| Model Number | 15-2 |
| Type | Liquid Level Sensor |
| Usage | Level measurement |
| Theory | Liquid Level switch |
| Output | UI250V lth:10A |
| working pressure | 0.1Mpa |
| Length | 1-40m |
| purpose | IP65 |
| control area | ≥03.m |
Wiring system
Packaging Display
