1. Fast heating: the minimum rate of heating is less than 1 second (rate of
heating is available for adjustment and control).
2. Wide coverage of heating: it can be used to heat various metal parts (replace removable
induction coil as per different operating switches).
3. Easy installation: it can be used once it is connected with power source, induction
coil as well as water supply pipe and rising pipe; it is small in
size and light in weight.
4. Easy operation: you can learn to operate it within several minutes.
5. Fast start-up: it can be started to perform heating operation on condition that
water and power supply is available.
6. Low power consumption: As compared with conventional vacuum tube high frequency
equipments, it can save the power by approximately 70%. The smaller
the size of the work piece is, the lower power consumption would
be.
7. High effectiveness: it has such features as uniform heating (it is applicable to
adjust the spacing of the induction coil to ensure the appropriate
temperature as required by each part of work piece), fast warming
and limited oxic horizon, and can guard against any waste after
annealing.
8. Comprehensive protection: it has such functions as overpressure, over-current, overheat and
water shortage alarm indications as well as automatic control and
protection.
9. Controllable temperature: it is applicable to control the temperature for heating work
pieces as per the preset heating time, and thereby control the
heating temperature at a certain technical point.
10. Comprehensive full load design: it can work continuously for 24 hours.
11. Small size and light weight: it has a weight of only several dozens of kilograms, of which,
the limited floor space can effectively save the workshop space.
12. Elimination of high voltage: it requires no step-up transformer which may produce
approximately ten thousand voltage, and thus can ensure the maximum
safety.
