Fully Automatic Aluminum Plastic Blister Packing Machine CE GMP And
FDA Approved
Characteristic:
1, DPP-260K Flat Type Blister Packing Machine could be separated to
enter elevator and clean workshop, adopt column pin location,
bolt-fixation, easy to serial production.
2, The die locate day location pin with precision, and press-board
dress up.
3, Main motor adopt frequency control: (punch frequency is 70
times/min). It can enact corresponding punch frequency according to
travel and fulled feeding easy or hard factor.
4, Adopt servo motor traction device, running steadily, synchronization nicety, change travel and
design the plate size at will on the range of 30-120mm.
5, Forming and heating plates close and open automatically, it
could protract time to boot-strap after put down heating plate,
limit wasting material less than one blister.
6, Air bed sealing, net-plate is hoisted by cylinder while stop.
Avoid making blister metamorphose by heat radialization while
settling, easy to clean the net-plate also, at the same time,play
the role of buffer when over-pressure, is propitious to prolong
machine usage life.
7, Up-lower net-plate male and female work in heat-sealing, there
are punctuate net-veins on the positive and negative(could
line-pressurize also). Because two side stress are equality, make
plate more level-up, improve pressurize capability as well.
8, Adopt balcony type structure, easy for operating and maintenance. And equipped with alarm system on the safety doors.
9, Alarm and stop while PVC is used up and discerption, easy to
replace PVC on time for workman. The PVC roll diameter can be maximum 800mm, to keep long time running.
10, All hardware and container are contact with medicament, adopt
stainless steel and innocuity produce, accord with “GMP” request.
Main Technical Data:
| Capacity (cycle/time) | AL/PL ≤70 AL/AL ≤40 |
| Range of stroke(mm) | 40-120 |
| Power | AC380V 50HZ 9.5KW |
| Overall dimension L*W*H(mm) | 4700*820*1820 |
| Weight(kg) | 2000 |
