Sign In | Join Free | My himfr.com |
|
XHBX1501 Product Description The transformer winding deformation tester can accurately judge the internal faults of the transformer based on the measurement of the characteristic parameters of the internal wind...
...transformer windings inside, using the frequency response analysis (FRA) method developed and improved by the developed countries. It applies to the detection of internal structure ......
... XHBX1502 Description According to the measurement of the characteristic parameters of the internal winding of the transformer, the XHBX1502 transformer winding deformation tester adopts the internal fault f...
IEC 60065 6KV 10/700 s Impulse Voltage Test Generator Product information: This impulse voltage test generator is required by IEC60065:2014 clause 10.2, 13.3.4 a), and IEC 60065:2014 clause 13.3.4 b), 14.2, IE...
... for measuring the DC resistance of the three-phase winding of the large-capacity transformer. It can measure the DC resistance of the three-phase winding at the same time. In case of the on-load voltage reg...
... and changing tapping switch. Measuring DC resistance of transformer winding, you can check out weld or connection quality of down-lead, the winding inter-turn short circuit or open circuit, and whether tap-...
Intelligent Gas Relay Calibrator Relay Protection Tester Full Automatic Features 1. Flow measurement: advanced method and good performance. Pressure-difference method can be used to measure impulse velocity, fl...
...Tester ZXFZ-H generator rotor AC impedance tester is a special instrument for judging whether there is a turn-to-turn short circuit in the generator rotor winding. It can measure the voltage, current, impeda...
...tester is a new generation of rapid tester that integrates the magnetic test, three-phase test and degaussing functions. It is an ideal device for measuring the DC resistance of large power transformers. Fun...
BS 1363-1 Figure 1 Test Pin For Impulse Voltage Test Probe Diameter 1mm Product information: The test pin conforms to BS1363-1: clause 12.6.1 b), figure 1, BS1363-2 clause 9.1.1 FIGURE 1. Technical parameters: ...
Digital Partial Discharge Detecting Tester , PD Detecting Instrument , Impulse Current Method PD Tester 1. Product introduction: Due to manufacturing or installation defects, discharge occurs in the insulated p...
Digital Partial Discharge Detecting Tester , PD Detecting Instrument , Impulse Current Method PD Tester 1. Product introduction: Due to manufacturing or installation defects, discharge occurs in the insulated p...
DC Brushless Motor Stator Tester / BLDC Motor / Stator Winding Measurement 1. Application: DC brushless motor stator testing in production line 2. Test item: AC Hipot, insulation resistance, surge, DC winding r...
... for measuring the DC resistance of the three-phase winding of the large-capacity transformer. It can measure the DC resistance of the three-phase winding at the same time. In case of the on-load voltage reg...
... for measuring the DC resistance of the three-phase winding of the large-capacity transformer. It can measure the DC resistance of the three-phase winding at the same time. In case of the on-load voltage reg...
... nominal diameter wider than 0.250mm. • It’s made up of three parts: pencil-impulse device and solvent thermostat device and a pencil-sharpener. • Pencil-impulse device can move forward after putting the pen...
Hot Winding Resistance Meter RXDC-3 Description: This device is Used for the winding temperature measurement of various household appliances and completed products(such as air conditioners, refrigerators, elect...
...Winding Resistance Meter, Total Power Consumption<15W, 2 Channels Standard:Conforms to IEC 60065 clause 7.1, IEC60950, IEC60335-1 clause 11 Household and similar electrical appliances-safety-Part 1:General r...
10KV Impulse Withstand Voltage Generator 1.2μs/50μs Voltage Wave 1. Introduction The impulse withstand voltage generator is a voltage wave tester with a waveform of 1.2μs/50μs. The frontier time is 1.2μs and th...
Product Description XHHV508-5 DC high voltage power supply is mainly used for impulse discharge during cable fault testing at voltage levels of 35kV and below; it can also be used for DC withstand voltage testi...