Solar Panel Mesh Clips

This innovative system is designed specifically to keep all birds from getting under solar arrays, protecting the roof, wiring, and equipment from damage. This non-penetrating system is fast and easy to install, and can be removed for service.

The wire mesh is supplied in rolls. The preferred technique is to cut it into six-foot lengths and straighten before getting onto the roof. Then, using a length of 2” X 4” timber, bend up the bottom inch of mesh to about 30 degrees. This “kick-out” helps to lock the mesh firmly into place

This innovative system is designed specifically to keep all birds from getting under solar arrays, protecting the roof, wiring, and equipment from damage.

Solar Panel Mesh Clips

A typical solar panel is approximately 1.6m tall and 1m wide, on a typical panel one should use 3 clips on each long edge and 2 clips on each short edge.