IBM PowerPC 405EP 32-Bit RISC Microprocessor 266MHz 385-Ball PBGA Embedded Processor

PPC405EP-3LB266C 32-Bit 266.66MHz CMOS PBGA385 RISC Microprocessor IBM25PPC405EP-3GB266C

Designed specifically to address embedded applications, the PowerPC 405EP (PPC405EP) provides a high-performance, low-power solution that interfaces to a wide range of peripherals by incorporating on-chip power management features and lower power dissipation requirements. This chip contains a high-performance RISC processor core, SDRAM controller, PCI bus interface, Ethernet interface, control for external ROM and peripherals, DMA with scatter-gather support, serial ports, IIC interface, and general purpose I/O. Technology: IBM CMOS SA-27E, 0.18 µm (0.11 µm Leff) Package: 31mm, 385-ball, enhanced plastic ball grid array (E-PBGA) Power (typical): 1.2W at 200MHz

Features:

IBM PowerPC 405 32-bit RISC processor core operating up to 333MHz with 16KB D- and Icaches • PC-133 synchronous DRAM (SDRAM) interface - 32-bit interface for non-ECC applications • 4KB on-chip memory (OCM) • External peripheral bus - Flash ROM/Boot ROM interface - Direct support for 8- or 16-bit SRAM and external peripherals - Up to five devices • DMA support for memory and UARTs. - Scatter-gather chaining supported - Four channels • PCI Revision 2.2 compliant interface (32-bit, up to 66MHz) - Asynchronous PCI Bus interface

- Internal or external PCI Bus Arbiter • Two Ethernet 10/100Mbps (full-duplex) ports with media independent interface (MII) • Programmable interrupt controller supports seven external and 19 internal edge-triggered or level-sensitive interrupts • Programmable timers • Software accessible event counters • Two serial ports (16750 compatible UART) • One IIC interface • General purpose I/O (GPIO) available • Supports JTAG for board level testing • Internal processor local Bus (PLB) runs at SDRAM interface frequency • Supports PowerPC processor boot from PCI memory

PowerPC 405EP Embedded Processor Data Sheet