Full Automatic Cable Tray Punching Machine 11kw 380V

Changeable Full Automatic Perforated Cable Trunking Roll Forming Machine With Punch Press

Operation of the pallet cable tray production equipment(cable tray roll forming machine/cable tray bending machine) must pay attention to the following points.

Before each start of the pallet type cable bridge production equipment(perforated cable tray roll forming machine/ perforated cable tray bending machine), the rotating part of the equipment should be filled with lubricating oil, the host chain and sprocket once a month to refuel, the reducer once a month to reduce damage to the machine. Punching and cutting mechanism should first be empty for a trial run, check the cylinder into and out, cut off the device to cut off, cut off the reset is normal and the chain cover shell installed. After commissioning the whole line of pallet type cable bridge production equipment(cable trunking roll forming machine/cable trunking bending machine), it should be empty running, normal, before test production. In the production process, it is strictly forbidden to use the plate head, plate edge with the dead fold, roll phenomenon of the plate into the mainframe, so as not to damage the pallet cable tray production equipment. Do not put your hand into the clamping roller to avoid accidents. (cable cover roll forming machine/cable cover bending machine)

Flow Chart of Changeable Full Automatic Perforated Cable Trunking Roll Forming Machine With Punch Press

8T hydraulic decoiler-Punch press-Roll forming machine--Outer table

Main Technical Parameters

Pictures of Changeable Full Automatic Perforated Cable Trunking Roll Forming Machine With Punch Press