Wet Proof Anti Interference High Frequency Spark Tester , Cable Testing Device
Wet Proof Anti Interference High Frequency Spark Tester, Cable Testing Device The Sine Wave Spark Tester is a fast and reliable instrument used to distinguish wire faults and detect bare wires. Its high-speed fault detection feature provides prompt information without worsening the condition of the wire after testing. The use of high frequency (3KHz) enables traditional commercial power frequency bead chain electrodes to be shortened to 120mm in the HS015E Model. Key Features
The Sine Wave Spark Tester is a fast and reliable instrument used to distinguish wire faults and detect bare wires. Its high-speed fault detection feature provides prompt information without worsening the condition of the wire after testing. The use of high frequency (3KHz) enables traditional commercial power frequency bead chain electrodes to be shortened to 120mm in the HS015E Model.
- Fast recovery time after fault (0.1 second)
- Occupies short space in line with improvement factor of 50 compared to traditional CT power frequency electrode
- Voltage Display: 0.0~15.0KV digit, 14.2mm LED display, Accuracy +/- 1% of reading
- Output Control: Front Panel Reset in Manual Mode with selectable closure time
- Limits fault current without damaging test equipment
- Short exposure time to corona does not degrade nor damage good insulation
- Distinguishes all wire faults and detects bare wire
- Safety Switch interlock
| Specification | ZL-1007 High Frequency Spark Tester For Cable |
|---|---|
| Output Voltage | 0.0~15.0KV R.M.S. |
| Test Voltage | 1.0~15.0KV R.M.S. |
| Cable Diameter | 0~25mm |
| Maximum Load Current | 4mA Resistive, 40mA Capacitive |
| Output Frequency | 2.5-3.5KHz normal |
| Electrode Lengths | Bead Chain 120mm |
| Fault Indication | Indicating lamp, Counting by Digital Counter |
| Output Control | 1 Form C relay Contacts (220VAC/5A) for all wire faults and bare wire faults detected |
| Input Control | SP1, SP2 input interlock control |
| Operating Model | Extruder Continuous Application |
| Power Source | 175~264 Volts, 180VA, Single phase, 50/60 Hz |
| Operation Temperature | +4~45°C |
| Operation Humidity | <90%RH |
| Signal Cable Lengths | 5M |
| Weight | Control Unit = 5 kgs, Electrode = 8.5 kgs |
| Dimension Controller | 360(L)x485(W)x90(H) mm |
| Gauge Head | 330(L)x200(W)x390(H) |
| Line Speed | 2000 M/min. maximum* |
Recommended Products
Video