Garage Door Remote Control

Garage Door Remote Control

Inquire Now

description :

USER MANUALUNIVERSAL REMOTE CONTROL GD5
RoboGuard?
FEATURES
1. Universal remote control.
2. Code learning up to 31 transmitters.
3. Operating range up to 150 meters.
4. 4 channel output.
APPLICATIONS:
1. Remote access control system.
2. Remote keyless entry system.
3. Remote gate garage door openers.
4. Remote security system.
SYSTEM CONTAINS:
1. Main unit. For decode and output control.
2. ReceiverARS434 / Dixie DX-32R. For signal receiving.
3. Transmitter (T408R434 / Dixie DX-4T). For encode and transmit ion.
INSTALLATION INSTRUCTION:
1. Fix the receiver ARS434 on nonmetal wall and plug the signal cable onto main unit.
2. Connect the system with power as per WIRING DAIGRAM.
3. Connect the system output wiring as per WIRING DAIGRAM and the output current draw maximums 300mA.
4. Output timing dependent on the timing press the button on the transmitter.
5. The output wiring and LED active as follows:
Brown wire and Red LED I for button I
Red wire and Red LED II for button II
Orange wire and Red LED III for button III
Yellow wire and Red LED IV for button IV
Green wire and Green LED for signal indication
INDEPENDENT CODE LEARNING SYSTEM:
1) Press and hold the learning switch (on PCB), till the Green LED is on.
2) Press the learning switch and counting the number (maximum 31) of position to store the code from transmitter (The green LED will follows with bright)
3) Green LED will light on after a while from stop counting and the system are waiting for code learning.
4) Press any button of the one of transmitter to register into the position number, the Green LED will report the number with flash.
5) Press and counting another number for learning other transmitters, any position number will erase old code by learning a new code.
6) The system will exit learning mode with green LED blinking if with out any action for about 6 seconds.
TRANSMITTER REGISTER REPORT:
The system can indication the register number of transmitter as follows process.
Press learning switch 5 times, the green LED steady on, then press any button on transmitter, system will report the register number of this transmitter with the green LED blinking.
Green LED long flash ---- means register number is 10.
Green LED short flash ---- means register number is 1.
For example: Register number 23, Green LED long flash 2 times and short flash 3 times.
USER NOTE:
1. Please read carefully USER MANUAL & WIRING DAIGRAM.
2. Prevent all equipments from water and humid.
3. Main unit power supply with 12V DC /0.5A adaptor or 12V battery.
4. Prevent the transmitter shock and dropping.
PROBLEMS AND SOLVED:
1. Remote range reducing: ----- Change the transmitter battery. (Type: 27A 12V DC)
2. Remote defeat: ----- 1) Change the transmitter battery. (Type: 27A 12V DC)
2) Check the main unit power supply.
3) Send back for service.
Garage Door Remote Contr