Description features:Features: 1) Orange, heavy bodied, medium set for CPVC pipe 1/2" through 12" in all classes and schedules. For cold, hot water (180°F) and industrial piping systems 2) Directions: Store below 90°F (33°C).Use only on CPVC plastic. Shake or stir before use. If jelled, replaoo. Use within 2 years of date stamped on bottom of can 3) Cut pipe square and deburr. Clean and dry joining surfaces. Check dry fit. For inter ference fit, pipe should push 1/4 to 3/4 way into fitting snugly 4) Use a suitable applicator at least 1/2 size of the pipe diameter; for larger sizes use brush or roller 5) Apply weld or primer and follow directions. Apply a full, even layer of cement on the pipe equal to the depth of socket. Coat the fitting socket with a medium layer. Avoid excess and puddling. On bell end pipe, do not coat beyond socket depth or allow cement to run beyond the bell. If necessary, apply a second, full layer on pipe. Cement should fill all gaps 4) Assemble while cement is wet. If not wet, recoat parts before assembly. Insure pipe bottoms into fitting socket. Twist 1/8 to 1/4 turn; to avoid pushout and allow for initial set, hold for about 30 seconds. Wipe off excess 5) Allow several minutes for good handing strength. At temperatures from 60°F (16°C) to 110°F (44°C), allow 24 hours cure for cold water systems and 48 hours cure for hot water. Between 40°F (5°C) and 60°F (16°C), allow 48 hours for cold water and 96 hours for hot water systems. Longer cure periods are necessary when system is used for chemicals. Cure time is affected by pipe diameter, pressure and temperature. Read IPS Set & Cure Time Schedule, Product Bulletin and MSDS. 6) Caution: Keep out of reach of children. Do not take internally. Keep away from heat, spark, open flame, other sources of ignition. Vapors may ignite explosively. Use only in well ventilated area; if not well ventilated, use forced ventilation or NIOSH approved respirator. Avoid breathing vapors. Avoid contact with skin and eyes. Use skin and eye protection. Eye contact may cause injury. Keep container closed. If inhaled, move into fresh air. If not breathing give artificial respiration. If breathing is difficult, give oxygen and call physician. In case of eye or skin contact, flush with water for 15mins. If irritation persists, get medical attention. If swallowed, give 2 glasses of water. Do not induce vomiting. Contact physician immediately. Contains tetrahydrofuran (109-99-9); methyl ethyl ketone (78-93-3); cyclohexanone (108-94-1) and CPVC resin (68648-82-8) Size: 236ml/tin (clear) Packing: 24 tins/ctn Carton dimensions: 41.5 x 28 x 11.2cm Volume: 0.013cbm N.W.: 6.5kg G.W.: 7kg