General Ceramic Tile Adhesive

General Ceramic Tile Adhesive

Inquire Now

description :

PROPERTIES1.Excellent workability and slump resistance
2.For internal and external use
3.Suitable for ceramic and most natural stone tiles
4.Easy application on all kinds of surfaces.
5.Versatile multipurpose tile adhesives
6.Frost and weather resistantSurface preparation:
All surfaces must be firm, rigid, clean, dry, sound and smooth. All grease, wax, oil, curing compounds, dust, plaster dropping sand paint must be removed prior to the application of the adhesiveInstruction:
1) Mixing ratio: 3:1 (approx. 7.5kg of water plus 25kg of powder)
2) Pour a suitable amount of water into a clean container and slowly add the powder into water with constant stirring until the lump-free mixture in achieved. Allow the mixture to stand for 5 minutes. Then re-stir. The product is now ready to use
3) Apply the adhesive onto the prepared substrate using the notched trowel. Do not spread more than 1m2 at time. Only apply as much adhesive as can be covered prior to adhesive skinning over. The adhesive must not be disturbed for at least 24 hours at which time grouting can take place
4) Press tiles onto the prepared substrate and use the correct cross spacer to control jointsDosage:
1) Use 3 x 3mm notched trowel, approx. 1.5~1.8kg/m2
2) Use 6 x 6mm notched trowel, approx. 2.8~3.0kg/m2
The above-mentioned dosages are recommended for the even substrate.Technical parameters:
1) Adjust time: >5min
2) Open time: ��0min
3) Surface drying time: approx. 2h
4) Appearance: white or grey powder
5) Shrinkage: ��0.50%
6) Normal shear strength: ��1.0MPa
7) Water resistance shear strength: ��0.7MPa
8) Heat Treatment resistance shear strength: ��0.7MPa
9) Freezing-thawing resistance shear strength: ��0.7MPaPrecautions:
1) Do not mix the cured adhesive with water and reuse it
2) Before using NIC-C1 on concrete, cement render, ensure that the wall
is well fastened and stands well
3) Do not use the product with the temperature below 5��C or above 40��C
4) For the tiles and stones with low water absorption, using NIC-C1 mixing with NIC-C3 or directly use NIC-C6
5) When laying tiles on the floor it is necessary to ensure that there are no voids under the tiles and the tiles are full supported by the adhesive Shelf life:
Unopened bags can be stored for up to 12 months in a cool dry environmentPacking:
25kg/bag, 5kg/bag